MyE28.com DEV

Posted: **Jan 16, 2015 10:58 PM**

Hey guys! Just wanted to see what everyone's thoughts were on placing your IAT sensor. I'm on MS2 and am using the GM open element sensor from DIY. No ICV.

Also where did you place your BOV? Here is a picture of my charge piping. Let me know what you guys think.

Also if anyone has VE and Timing maps for a US B34 I could look over pleas let me know.

Thank you.

Posted: **Jan 17, 2015 11:49 AM**

I'm on my phone, can't see the iat but the bov looks good. PM me your email, I have what you're looking for.

Posted: **Jan 22, 2015 7:52 PM**

I would place the iat in the charge piping up near the front. I installed mine in the intake manifold directly behind the throttle body, however, I have had hot start issues. I think the intake manifold gets heat soaked.
Good looking project!
marc

Posted: **Jan 22, 2015 9:23 PM**

i put mine directly into the cylinder 6 intake runner. seems to not have issues with heak soak

MyE28.com DEV

IAT sensor placement and charge piping questions.

IAT sensor placement and charge piping questions.

Re: IAT sensor placement and charge piping questions.

Re: IAT sensor placement and charge piping questions.

Re: IAT sensor placement and charge piping questions.